-
Categories
- DIY Learning / STEM Kits
- DIY Robots & Parts
- Drone & Parts
- Electronic Components
- Hardware Projects
- Home & Outdoor
- PCB & 3D Model
- Software Projects
These N20 6V 200RPM Gear Motor With Encoder is intended for use at 6V. Though in general, these kinds of motors can run at voltages above and below this nominal voltage; so they should comfortably operate in the 3 – 6 V range (rotation can start at voltages as low as 0.5 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gear motors are available in a wide range of gear ratios—from 5:1 up to 1000:1. Except 1000:1 gear ratio versions, all of the micro metal gear motors have the same physical dimensions; so one version can be easily swapped for another if your design requirements change.
1 x N20 6V 200RPM Micro Metal Gear Motor With Encoder.
1 x Connector(14 cm).
No review given yet!
On prepaid orders above INR 1000
COD available for orders above INR 1000
Shipped within 24 hours
Mon to Sat - 10 AM to 6 PM
You need to Sign in to view this feature
This address will be removed from this list
